Closing the loop in the electroplating i

The electrodialysis has been already applied for metals recovery in plating processes, however, according to the operational settings, this technology may present loss of efficiency. The aim of this work consists on determine the electrodialysis operational parameters necessary to scale up the process and to close the loop in the nickel electroplating industry. The evaluation in bench scale using synthetic effluents allowed determinations about limiting current density, stack configuration and desired characteristics for the solutions produced by electrodialysis. The parameters defined in these tests were applied in an industrial-scale electrodialysis, in a continuous process connected to an industrial rinse water line of nickel plating. The operation in industrial scale confirmed that the obtained solutions have enough quality to be reused in the nickel plating process. The reuse of concentrated stream allowed savings and ground rock for nickel plating. The diluted solution reached conditions similar to tap water; this characteristic allowed the reuse of this solution as rinse water, reducing 90% the volume of effluent sent to the wastewater treatment plant. The reused solutions did not bring harm to the visual quality of the deposit and its protective properties. Thus near pollutant emissions, electrodialysis treatment may be of significant interest to the electroplating industry, providing a closed loop SALT.