Mirjana FILIPOVIC, Endre ROMHANJI and Zeljko KAMBEROVIC
The chemical composition and morphology of M7C3 eutectic carbides in 19 mass% Cr–2.8 mass% C white iron with up to 4.7 mass% V additions have been studied. Eutectic colonies are mainly composed of a very fine rod-like carbides at the center and become coarser rod-like or blade-like with increased distance from the center. The volume fraction, size and distribution of rod-like and blade-like carbides in the eutectic colonies are changing with increasing vanadium content in the alloys. The formation of the eutectic colonies of different morphology is the consequence of the segregation of alloying elements in the alloy melt, which was confirmed by EDS analysis of the chemical composition of carbides. Three different compositions of M7C3 carbides were found in all tested alloys. The main difference between them is in the amount of chromium and iron and in the degree of their replacement by vanadium. Due to different melt composition in particular zones, the constitutional undercooling, and subsequently the growth rate, will be different, which will induce the formation of eutectic colonies of different morphologies.
@article{bc98c7dc-eb20-4082-822b-27eb5a97b5b7,
title={Chemical Composition and Morphology of M7C3 Eutectic Carbide in High Chromium White Cast Iron Alloyed with Vanadium},
author={Mirjana FILIPOVIC and Endre ROMHANJI and Zeljko KAMBEROVIC},
year={2012},
language={en}
}TY - JOUR TI - Chemical Composition and Morphology of M7C3 Eutectic Carbide in High Chromium White Cast Iron Alloyed with Vanadium AU - Mirjana FILIPOVIC AU - Endre ROMHANJI and Zeljko KAMBEROVIC PY - 2012 LA - en ER -
Mirjana Filipović, Željko Kamberović, Marija Korać
Experimental results indicate that the volume fraction of the carbide phase, carbide size and distribution had an important influence on the wear resi
M. Filipovic, Z. Kamberovic, M. Korac, and M. Gavrilovski
The objective of this investigation was to set down (on the basis of the results obtained by the examination of white cast iron alloys with different
Aleksandar Mihajlović, Željko Kamberović, Marija Korać, Milorad Gavrilovski, Nikola Jovanović
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blis
Wei Xu, Gaojian You
The surface properties of aviation titanium alloys critically influence service safety and reliability, yet there is limited guidance on laser power s
Fathi Habashi
In the 1940s hydromtallurgy benefitted a great deal from Manhattan Project in USA, then in the 1950s a new technology was introduced by Sherritt-Gordo
Biebuma J. J, Peter Ndubuisi Asiagwu
Air Traffic Control (ATC) radar propagation with a short pulse duration lacks the capability of long range detection of targets. Thus, pulse compressi