Bekir GÜNEY, Serkan DAL
In recent years, efforts have been made to address the shortcomings of conventional brazing foils stemming from solidification processes through optimization of production parameters and the addition of filler metals. Amorphous brazing foils with low melting points, rapid solidification, and the addition of filler metals are being produced. This study aims to review previous work in this field and investigate the spectrographic properties of joints made with amorphous brazing foils. Within the scope of this study, dissimilar duplex stainless steel and medium carbon AISI 4140 steel were joined using MBF-51 metallic foil using the vacuum diffusion bonding technique, which boasts several properties such as exceptional processing accuracy and suitability for large-scale production. Microstructure and EDS analyses demonstrated that the joint produced was mechanically and metallurgically well bonded.
@article{f1e2bb0a-0d31-41f5-a4b8-39d378ee4f5b,
title={A Study of Recent Developments in Amorphous Brazing Foils },
author={Bekir GÜNEY and Serkan DAL},
year={2025},
language={en}
}TY - JOUR TI - A Study of Recent Developments in Amorphous Brazing Foils AU - Bekir GÜNEY AU - Serkan DAL PY - 2025 LA - en ER -
Mirjana Filipović, Željko Kamberović, Marija Korać
Experimental results indicate that the volume fraction of the carbide phase, carbide size and distribution had an important influence on the wear resi
Aleksandar Mihajlović, Željko Kamberović, Marija Korać, Milorad Gavrilovski, Nikola Jovanović
Technological procedure of slow cooling slag from primary copper production is applied in the purpose of copper recovery in the level of 98.5% to blis
M. Filipovic, Z. Kamberovic, M. Korac, and M. Gavrilovski
The objective of this investigation was to set down (on the basis of the results obtained by the examination of white cast iron alloys with different
Mirjana FILIPOVIC, Endre ROMHANJI and Zeljko KAMBEROVIC
The chemical composition and morphology of M7C3 eutectic carbides in 19 mass% Cr–2.8 mass% C white iron with up to 4.7 mass% V additions have been stu
Roger Rumbu
Fluid-bed roasters are widely used in extractive metallurgy for roasting sulfide ores, offering superior efficiency through enhanced heat and mass tra
Dr. Ajay Kumar Shukla
This document outlines the scope and foundational principles of a course on extractive metallurgy. It introduces the learning objectives, emphasizing